This paper presents a step-by-step design of noncircular gears. From the diagram of angular velocity ratio of a noncircular gear pair, the pitch curves of the two mating gears are determined, and the perimeter of the pitch curve has been divided into equal-length segments by the number of teeth. A master tooth profile, which is a composite curve of circular arcs that represents involute, has been introduced. A noncircular gear pair has been designed by imposing the master tooth on the divided points of the pitch curve, and a full fillet has been achieved between neighbour teeth. Thus, the whole profile of the noncircular gear is a composite curve of arcs only, and consequently NC codes for wire EDM can be easily generated.