Using central composite design, we have designed optimization of the manufacturing of processed butter. And response surface analysis by least-square regression was used Statistical Analysis System(SAS). Central composite design can be achieved by response surface techniques that allow flexibility in modeling and analysis. Response surface methodology(RSM) was used to optimize hardness(%) using as independent variables; the content of butter($X_1$), ranging from 50 to 90(%), the content of soybean oil($X_2$), from 0 to 20(%), and the hydrogenated soybean oil($X_3$) from 0 to 4(%). The results on the regression coefficients calculated for overrun by response surface by least-square regression(RSREG) were followed. It was considered that the linear regression was significant(p<0.01). As for the processed butter, the regression model equation for the hardness(Y, %) to the change of an independent variable could be predicted as follow: $Y=60.88-8.92X_2-{29.3X_2}^2$. The optimal for the manufacturing of processed butter were determined at the content of butter of 88.22%, soybean oil of 6.71% and hydrogenated soybean oil of 2.36%, respectively. Optimum compositions were resulted in hardness of 65.78 N. Finally the reference sample(Butter in the morning, Seoul Dairy Co-op.) and processed butter manufacturing under the optimal conditions were compared with spreadability test. The spreadability scores result from reference sample and butter under optimal conditions was not found a significant difference.