Large load is required in forging of large-scale components which becomes a critical restriction in practice. In the present study, two methods of incremental forging were investigated for the purpose of reducing the load required for forging of large and thick plates. The forging was applied primarily to obtain fine grains by imposing large amount of plastic deformation to the plates. One was to use nine strokes with a flat die and the other was to use three strokes with a curved die. The die moves vertically in the former while it moves vertically as well as rolls horizontally in the latter. Deformation of the slab in each case was analyzed by rigid-plastic finite element method and as a result, variations of load and slab holding force, and distributions of effective strain and thickness were predicted.