The purpose of this work is to develop of a press forming process for mobile phone battery cover as an alternative to the current manufacturing process by laser welding. This press forming process consists of a combination of bending, side pressing and side bending operations. The dimensional error for each process was investigated by finite element(FE) analysis and the Taguchi optimization method. The spreading of the cover width in the side pressing process was adjusted by modifying the blank shape with a notch. The over-bending method was adopted to compensate the spring-back which occurs after bending. Forming experiments were performed to verify the reliability of the developed press forming process. In addition, the strength of the product was evaluated to verify the suitability of the battery cover manufactured with this new press forming process. The results of the forming experiments indicate that the dimensional accuracy of the battery cover is within the required tolerance. The strength of the battery cover was evaluated to 547N which is larger than required strength of 400N.