기관회원 [로그인]
소속기관에서 받은 아이디, 비밀번호를 입력해 주세요.
개인회원 [로그인]

비회원 구매시 입력하신 핸드폰번호를 입력해 주세요.
본인 인증 후 구매내역을 확인하실 수 있습니다.

회원가입
서지반출
졸-겔 방법을 이용한 LiMn2O4 박막 이차 전지 제작 및 전기화학적 특성 조사
[STEP1]서지반출 형식 선택
파일형식
@
서지도구
SNS
기타
[STEP2]서지반출 정보 선택
  • 제목
  • URL
돌아가기
확인
취소
  • 졸-겔 방법을 이용한 LiMn2O4 박막 이차 전지 제작 및 전기화학적 특성 조사
저자명
이중한,김광주,Lee. J.H.,Kim. K.J.
간행물명
韓國眞空學會誌
권/호정보
2011년|20권 3호|pp.205-210 (6 pages)
발행정보
한국진공학회
파일정보
정기간행물|
PDF텍스트
주제분야
기타
이 논문은 한국과학기술정보연구원과 논문 연계를 통해 무료로 제공되는 원문입니다.
서지반출

기타언어초록

졸-겔(sol-gel) 방법을 이용하여 스피넬(spinel) 구조의 산화물 $LiMn_2O_4$ 박막을 Pt/Ti/$SiO_2$/Si 기판 위에 제작하여 그 구조적 성질 및 이차 전지 전기화학적 특성을 조사하였다. 박막에서의 Li/Mn 몰비(molar ratio)가 0.5 미만일 경우 박막에 $LiMn_2O_4$ 상뿐만 아니라 $Mn_2O_3$ 상이 존재함이 관측되었다. $LiMn_2O_4$ 박막을 이용한 반전극(half cell) 전지를 제작하여 충전-방전 순환과정을 반복수행 하였고, 과정 시작 전후에 X-ray diffraction 및 Raman spectroscopy 측정을 통하여 과정 중 발생하는 박막의 구조적 성질 변화를 조사하였다. 순수한 $LiMn_2O_4$ 박막 전지의 경우 충전-방전 횟수가 증가함에 따라 방전 용량은 서서히 감소하여 300회에 이르러서는 초기 용량의 72%로 줄어들었다. 이와 같은 결과는 충전-방전 과정 중 스피넬 구조의 사면체 자리로부터 탈리되었다가 다시 삽입되는 $Li^+$ 이온 수의 감소 및 이에 따르는 $Mn^{4+}$ 이온 수 증가와 관련이 있는 것으로 해석된다. 또한, 순환 횟수가 증가함에 따라 박막 내에 $Mn_2O_3$ 상의 밀도가 점차 증가함이 관측되었다.

기타언어초록

Structural and electrochemical properties of spinel oxide $LiMn_2O_4$ thin films prepared by using a sol-gel method on Pt/Ti/$SiO_2$/Si substrates were investigated. When Li/Mn molar ratio of the film was smaller than 0.5, $Mn_2O_3$hase was found to coexist with $LiMn_2O_4$. Half-cell batteries fabricated using the $LiMn_2O_4$ films as the cathode were put into chargedischarge (C-D) cycles and the change in structural properties of the cathode after the cycles was examined by X-ray diffraction and Raman spectroscopy. As the C-D cycle number increases, the discharge capacity of pure $LiMn_2O_4$ battery gradually decreases, being reduced to 72% of the initial capacity at 300 cycles. Such capacity fading is attributable to the decrease in the number of $Li^+$ ions that return to the tetrahedral sites of the spinel structure during the discharge step and the resultant increase in $Mn^{4+}$ density in the film. Also, $Mn_2O_3$ phase gradually appeared in the film as the cycle number increases.