계면접착력 향상을 위해 실린더형 RF 플라즈마 발생기를 이용하여 Jute fiber의 표면을 아르곤가스로 처리하였고 최적 처리조건을 설정하였다. 플라즈마 강도, 가스압력, 및 처리시간을 변경한 후 이러한 인자들이 황마섬유 표면모폴로지, 섬유 인장강도, 및 폴리프로필렌과의 모델복합체에서 계면접착강도에 미치는 영향을 조사하였다. 플라즈마 처리인자에 따라 황마섬유의 표면은 거칠어졌다. 가스압력의 영향은 처리시간 및 플라즈마 강도의 영향보다 다소 낮게 나타났다. 플라즈마 강도와 시간에 따라 황마섬유의 강도는 약 25% 감소한 반면, 가스압력의 영향은 크게 나타나지 않았다. 계면전단강도 (IFSS)를 기준으로 결정된 최적 플라즈마 처리조건은 처리시간 30 s, 전력 40 W, 가스압력 30 mTorr로 나타났다.
A jute fiber surface was modified with argon gas in a cylinder type RF plasma generator to enhance the interfacial bond strength and to optimize the plasma treatment condition. The plasma power, gas pressure, and treat time were varied to figure out any effect of those parameters on the morphology and mechanical strength of jute fibers, and the interfacial bond strength for a model composite with polypropylene resin. As the severity of plasma treatment was increased, the surface of jute fibers became rougher. Gas pressure was less effective in roughening of the surface compared with those of treat time and plasma power. Approximately 25% drop in tensile strength of jute fibers was observed for the parameters of treat time and plasma power, while little deterioration was found for gas pressure, with increasing the severity. Based on the interfacial shear strength (IFSS), the optimum plasma treatment condition was determined to be treat time of 30 s, plasma power of 40 W, and gas pressure of 30 mTorr.
