This study tried to find a suitable method for enhancing the foam stability of cationic surfactants that normally generate less foam or no foam. Several trials were made to enhance the foam stability: addition of anionic surfactant, colloids and polymer. Cationic starch (CA-ST) did not form foam at all, while the foam stability of two other cationic surfactant also showed low levels; methyl triethanol ammonium methyl sulfate distearyl ester (CEQ90) for 46 sec. and Cetyl trimethyl ammonium chloride (CM29) for 31 seconds. Foam stability of cationic surfactants were significantly affected by addition of anionic surfactant, sodium dodecyl sulfate (SDS). Foam stability of CA-ST was significantly enhanced by addition of SDS, while those of CEQ90 and CM29 were decreased. Addition of colloids ($SiO_2$, kaolin) and polyvinyl alcohol (PVA) enhanced foam stabilities of CEQ90 and CM29. However, CA-ST did not form foam even in the presence of colloids or PVA. Effect of simultaneous addition of colloids and anionic surfactant on foam stability of cationic surfactant showed that foam stability of cationic surfactant was more influenced by addition of anionic surfactant than colloids. Effect of simultaneous addition of PVA and anionic surfactant on the foam stability of cationic surfactant also showed that presence of anionic surfactant significantly affect the foam stability of cationic surfactant. Foam stability of CA-ST was greatly increased to 8,780 seconds by addition of SDS 0.14% and PVA 2.5%. The foam stability of CA-ST was 8 times higher than CEQ 90. This study suggested that cationic surfactants not forming foam can generate foam by addition of anionic surfactant and its stability can be additionally increased by addition of colloids and PVA. The study results showed that enhancement in foam stability of cationic surfactant was prominently affected by the concentration of anionic surfactant added.