Variable valve timing (VVT) and cylinder deactivation (CDA) are promising methods in reducing fuel consumption and emission at part load in SI engines. An SI engine which uses electromagnetic valvetrain (EMV) will eliminate flow restriction from the throttle valve and produce higher indicated mean efficiency pressure (IMEP) due to the disabling of some of the working cylinders at part load. Therefore, pumping loss can be significantly reduced at part-load conditions. In addition, duration and timing of valve events are variably controlled at different operating conditions. This contributes to the improvement of engine efficiency. In this study, a dynamic model of an unthrottled SI engine has been developed to simulate the engine cycle. The model uses an EMV system that allows valvetrain control and cylinder deactivation techniques to be carried out in simulation flexibly. The simulated results find the optimal valve timing for different engine speeds. The optimal timing of intake valve closing depends on engine speed linearly, while the intake valve opening insignificantly influences engine performance. Additionally, this study also shows that cylinder deactivation modes can be successfully applied in improving engine efficiency at different engine loads. Different cylinder deactivation strategies have been applied for the full range of engine loads. It is concluded that the two-cylinder deactivation mode (50% CDA) considerably improves fuel consumption at low engine load. Meanwhile, one-cylinder deactivation (25% CDA) is an optimal fuel economy mode at medium engine load. With proper uses of VVT and CDA strategies, the efficiency of an SI engine can be increased more than 30% at low engine load and 11.7 % at medium engine load.