Radical melt graft copolymerizations of poly (lactic acid) (PLA) with amide monomers using benzoyl peroxide as an initiator during reactive extrusion is studied. The effects of two monomer types at various concentrations, reaction temperatures and initiator concentrations on the grafting yield are investigated. The results showed that percentage of grafting was significantly enhanced by increasing benzoyl peroxide concentrations up to 12 mpm and then decreased by an increase in the initiator concentration. Furthermore, increasing each monomer concentration up to 450 mpm, improved the grafting yield significantly. Further increase brings about a marked fall in the grafting yield. Fourier Transform Infrared Spectroscopy (FTIR), back titration and nitrogen analyses confirmed that monomers of acrylamide and methacrylamide were successfully grafted onto PLA. The Gel Permeation Chromatography (GPC) data showed that the molecular weight of the grafted PLA samples under optimum conditions does not show any dramatic drop of PLA molecular weight by thermal degradation or hydrolysis of polyester chains, while the polydispersity index is poorly affected by the chemical modification of PLA. Also, the monomer structures affected the grafting yield as well as polymer chain combination. In addition under the same conditions, the grafting yield of acrylamide was more than that of methacrylamide. Thermal properties, molecular weight, density, moisture regain and tensile properties of the samples were also measured.