학지사 뉴논문

총 1,466건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

1231.

Hydrogen storage capacity of highly porous carbons synthesized from biomass-derived aerogels

Yong-Ki Choi, Soo-Jin Park 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 9 127-131 (5 pages)

Yong-Ki Choi, Soo-Jin Park 저
...
- 1,500원
In this work, highly porous carbons were prepared by chemical activation of carbonized biomass-derived aerogels. These aerogels were synthesized from watermelon flesh using a hydrothermal reaction. After carbonization, chemical activation was conducted using potassium hydroxide to enhance the specific surface area and microporosity. The micro-structural properties and morphologies were measured by X-ray diffraction and scanning electron microscopy, respectively. The specific surface area and...
1232.

Stabilization of pitch-based carbon fibers accompanying electron beam irradiation and their mechanical properties

Mi-Seon Park, Yoonyoung Ko, Min-Jung Jung, Young-Seak Lee 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 8 121-126 (6 pages)

Mi-Seon Park, Yoonyoung Ko, Min-Jung Jung, Young-Seak Lee 저
...
- 3,000원
Carbon fibers are prepared by stabilizing pitch fibers accompanying electron beam (E-beam) irradiation. The carbon fibers pretreated by E-beam irradiation achieve a higher stabilization index than the carbon fibers that are only heat-stabilized. In addition, the carbon fibers subjected to E-beam irradiation in the stabilization step exhibit a comparable tensile strength to that of general purpose carbon fibers. The carbon fibers pretreated with an absorbed dose of 3000 kGy have a tensile...
1233.

Functionalization of graphene nanoplatelets using sugar azide for graphene/epoxy nanocomposites

Saswata Bose, Lawrence T. Drzal 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 5 101-106 (6 pages)

Saswata Bose, Lawrence T. Drzal 저
...
- 3,000원
We report a covalent functionalization of graphene nanoparticles (GnPs) employing 2,3,4-Tri-O-acetyl-β-D-xylopyranosyl azide followed by fabrication of an epoxy/functionalized graphene nanocomposite and an evaluation of its thermo-mechanical performance. Successful functionalization of GnP was confirmed via thermal and spectroscopic study. Raman spectroscopy indicated that the functionalization was on the edge of the graphene sheets; the basal plane was not perturbed as a result of the...
1234.

Preparation and characterization of carbon fiber-reinforced thermosetting composites: a review

Fan-Long Jin, Soo-Jin Park 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 1 67-77 (11 pages)

Fan-Long Jin, Soo-Jin Park 저
...
- 4,000원
Carbon fibers (CFs) have a unique combination of properties which allow them to be widely used as reinforcing materials in advanced polymer composites. The mechanical properties of CF-reinforced polymer composites are governed mainly by the quality of interfacial adhesion between the CFs and the polymer matrix. Surface treatments of CFs are generally carried out to introduce chemical functional groups on the fiber surfaces, which provide the ability to control the surface characteristics of CFs....
1235.

Effect of surface treatment of graphene nanoplatelets for improvement of thermal and electrical properties of epoxy composites

Minjae Kim, Yeongseon Kim, Sung Hyeon Baeck and Sang Eun Shim 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 5 34-40 (7 pages)

Minjae Kim, Yeongseon Kim, Sung Hyeon Baeck and Sang Eun Shim 저
...
- 3,000원
In this study, in order to improve the thermal and electrical properties of epoxy/graphene nanoplatelets (GNPs), surface modifications of GNPs are conducted using silane coupling agents. Three silane coupling agents, i.e. 2-(3,4-epoxycyclohexyl)-ethyltrimethoxysilane (ETMOS), 3-glycidoxypropyltriethoxysilane (GPTS), and 3-glycidoxypropyltrimethoxysilane (GPTMS), were used. Among theses, GPTMS exhibits the best modification performance for fabricating GNP-incorporated epoxy composites. The effect...
1236.

An overview of new oxidation methods for polyacrylonitrile?based carbon fibers

Hye Kyoung Shin, Mira Park, Hak-Yong Kim and Soo-Jin Park 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 2 11-18 (8 pages)

Hye Kyoung Shin, Mira Park, Hak-Yong Kim and Soo-Jin Park 저
...
- 3,000원
The process of oxidizing polyacrylonitrile (PAN)-based carbon fibers converts them into an infusible and non-flammable state prior to carbonization. This represents one of the most important stages in determining the mechanical properties of the final carbon fibers, but the most commonly used methods, such as thermal treatment (200°C to 300°C), tend to waste a great deal of process time, money, and energy. There is therefore a need to develop more advanced oxidation methods for PAN precursor...
1237.

Effects of comonomer with carboxylic group on stabilization of high molecular weight polyacrylonitrile nanofibrous copolymers

Danyun Lei, Kesavan Devarayan1, Xiang-Dan Li, Woong-Ki Choi, Min-Kang Seo and Byoung-Suhk Kim 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 9 290-294 (5 pages)

Danyun Lei, Kesavan Devarayan1, Xiang-Dan Li, Woong-Ki Choi, Min-Kang Seo and Byoung-Suhk Kim 저
...
- 1,500원
New precursors, poly(acrylonitrile-co-crotonic acid) (poly(AN-CA)) and poly(acrylonitrile-co-itaconic acid-co-crotonic acid) (poly(AN-IA-CA)) copolymers, for the preparation of carbon fibers, were explored in this study. The effects of comonomers with acidic groups, such as crotonic acid (CA) and/or itaconic acid (IA), on the stabilization of nanofibrous polyacrylonitrile (PAN) copolymers were studied. The extent of stabilization, evaluated by Fourier transform infrared spectroscopy, revealed...
1238.

Novel reforming of pyrolized fuel oil by electron beam radiation for pitch production

Jin-Young Jung, Mi-Seon Park, Min Il Kim and Young-Seak Lee 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 5 262-267 (6 pages)

Jin-Young Jung, Mi-Seon Park, Min Il Kim and Young-Seak Lee 저
...
- 3,000원
Pyrolized fuel oil (PFO) was reformed by novel electron beam (E-beam) radiation, and the elemental composition, chemical bonds, average molecular weight, solubility, softening point, yields, and density of the modified patches were characterized. These properties of modified pitch were dependent on the reforming method (heat or E-beam radiation treatment) and absorbed dose. Aromaticity (Fa), average molecular weight, solubility, softening point, and density increased in proportion to the...
1239.

Properties of multi-walled carbon nanotube reinforced epoxy composites fabricated by using sonication and shear mixing

Min Ye Koo, Hon Chung Shin, Won-Seok Kim and Gyo Woo Lee 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 4 255-261 (7 pages)

Min Ye Koo, Hon Chung Shin, Won-Seok Kim and Gyo Woo Lee 저
...
- 3,000원
than those of the other specimens. The Young’s moduli of the specimens increased as the nanotube filler content was increased in the matrix. As the concentrations of nanotubes filler were increased in the composite specimens, their storage and loss moduli also tended to increase. The specimen having a nanotube filler content of 0.6 wt% showed higher thermal conductivity than that of the other specimens. On the other hand, in the measurement of thermal expansion, specimens having 0.4 and 0.6 wt%...
1240.

Adsorption of volatile organic compounds using activated carbon fiber filter in the automobiles

Hyung Suk Moon, In Soo Kim, Sin Jae Kang, Seung Kon Ryu 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 8 203-209 (7 pages)

Hyung Suk Moon, In Soo Kim, Sin Jae Kang, Seung Kon Ryu 저
...
- 3,000원
The adsorption of volatile organic compounds (VOCs) was carried out using an activated carbon fiber (ACF) filter in an automobile. The adsorption capacities of formaldehyde, toluene, and benzene on an ACF filter were far better than those of a polypropylene (PP) mat filter and combined (PP+activated carbon) mat filter by batch adsorption in a gas bag. In a continuous flow of air containing toluene vapor through an ACF packed bed, the breakpoint time was very long, the length of the unused bed...

한주간 이슈검색어