학지사 뉴논문

총 3,053건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

2951.

Microwave-assisted pretreatment technologies for the conversion of lignocellulosic biomass to sugars and ethanol: a review

Pradeep Puligundla, Sang-Eun Oh, Chulkyoon Mok 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 1 1-10 (10 pages)

Pradeep Puligundla, Sang-Eun Oh, Chulkyoon Mok 저
...
- 3,000원
Lignocellulosic biomass conversion to biofuels such as ethanol and other value-added bio-products including activated carbons has attracted much attention. The development of an efficient, cost-effective, and eco-friendly pretreatment process is a major challenge in lignocellulosic biomass to biofuel conversion. Although several modern pretreatment technologies have been introduced, few promising technologies have been reported. Microwave irradiation or microwave-assisted methods (physical and...
2952.

Structural properties of reduced graphene oxides prepared using various reducing agents

Byung Soo Lee, Yangjin Lee, Jun Yeon Hwang, Young Chul Choi 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.4 5 255-259 (5 pages)

Byung Soo Lee, Yangjin Lee, Jun Yeon Hwang, Young Chul Choi 저
...
- 1,500원
2953.

Influence of defective sites in Pt/C catalysts on the anode of direct methanol fuel cell and their role in CO poisoning: a first-principles study

Soonchul Kwon, Seung Geol Lee 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.3 6 198-202 (5 pages)

Soonchul Kwon, Seung Geol Lee 저
...
- 1,500원
Carbon-supported Pt catalyst systems containing defect adsorption sites on the anode of direct methanol fuel cells were investigated, to elucidate the mechanisms of H2 dissociation and carbon monoxide (CO) poisoning. Density functional theory calculations were carried out to determine the effect of defect sites located neighboring to or distant from the Pt catalyst on H2 and CO adsorption properties, based on electronic properties such as adsorption energy and electronic band gap. Interestingly,...
2954.

Bulk graphite: materials and manufacturing process

Sang-Min Lee, Dong-Su Kang and Jea-Seung Roh 한국탄소학회 Carbon Letters 12 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.3 1 135-146 (12 pages)

Sang-Min Lee, Dong-Su Kang and Jea-Seung Roh 저
...
- 4,100원
Graphite can be classified into natural graphite from mines and artificial graphite. Due to its outstanding properties such as light weight, thermal resistance, electrical conductivity, thermal conductivity, chemical stability, and high-temperature strength, artificial graphite is used across various industries in powder form and bulk form. Artificial graphite of powder form is usually used as anode materials for secondary cells, while artificial graphite of bulk form is used in steelmaking...
2955.

Mechanisms of Na adsorption on graphene and graphene oxide: density functional theory approach

Hye Sook Moon, Ji Hye Lee, Soonchul Kwon, Il Tae Kim, Seung Geol Lee 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 7 116-120 (5 pages)

Hye Sook Moon, Ji Hye Lee, Soonchul Kwon, Il Tae Kim, Seung Geol Lee 저
...
- 1,500원
We investigated the adsorption of Na on graphene and graphene oxide, which are used as anode materials in sodium ion batteries, using density functional theory. The adsorption energy for Na on graphene was -0.507 eV at the hollow sites, implying that adsorption was favorable. In the case of graphene oxide, Na atoms were separately adsorbed on the epoxide and hydroxyl functional groups. The adsorption of Na on graphene oxide-epoxide (adsorption energy of -1.024 eV) was found to be stronger than...
2956.

Characterization and influence of shear flow on the surface resistivity and mixing condition on the dispersion quality of multi-walled carbon nanotube/polycarbonate nanocomposites

Young Sil Lee, Kwan Han Yoon 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 3 86-92 (7 pages)

Young Sil Lee, Kwan Han Yoon 저
...
- 3,000원
Multi-walled carbon nanotube (MWCNT)/polycarbonate (PC) nanocomposite was prepared by direct melt mixing to investigate the effect of the shear rate on the surface resistivity of the nanocomposites. In this study, an experiment was carried out to observe the shear induced orientation of the MWCNT in the polymer matrix using a very simple melt flow indexer with various loads. The compression-molded, should be eliminated. MWCNT/PC nanocomposite sample exhibited lower percolation thresholds (at 0.8...
2957.

Activated carbons prepared from mixtures of coal tar pitch and petroleum pitch and their electrochemical performance as electrode materials for electric double-layer capacitor

Eunji Lee, Soon Hyung Kwon, Poo Reum Choi, Ji Chul Jung, Myung-Soo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 2 78-85 (8 pages)

Eunji Lee, Soon Hyung Kwon, Poo Reum Choi, Ji Chul Jung, Myung-Soo Kim 저
...
- 3,000원
Activated carbons (ACs) were prepared by activation of coal tar pitch (CTP) in the range of 700°C-1000°C for 1-4 h using potassium hydroxide (KOH) powder as the activation agent. The optimal activation conditions were determined to be a CTP/KOH ratio of 1:4, activation temperature of 900°C, and activation time of 3 h. The obtained ACs showed increased pore size distribution in the range of 1 to 2 nm and the highest specific capacitance of 122 F/g in a two-electrode system with an organic...
2958.

Modification of isotropic coal-tar pitch by acid treatments for carbon fiber melt-spinning

Mi Jung Yoo, Hyo Jun Ko, Yun-Soo Lim and Myung-Soo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 3 247-254 (8 pages)

Mi Jung Yoo, Hyo Jun Ko, Yun-Soo Lim and Myung-Soo Kim 저
...
- 3,000원
In this work, thermal treatment accompanied with different acid treatments was applied to a commercial coal tar pitch (CTP) to obtain a spinnable precursor pitch for carbon fiber. In the case of thermal treatment only, a relatively high reaction temperature of between 380°C and 400°C was required to obtain a softening point (SP) range of 220°C-260°C and many meso-phase particles were created during the application of high reaction temperature. When nitric acid or sulfuric acid treatment was...
2959.

Excellent field emission properties from carbon nanotube field emitters fabricated using a filtration-taping method

Dong Hoon Shin, Seung Il Jung, Ki Nam Yun, Guohai Chen, Seok-Gy Jeon, Jung-Il Kim, Cheol Jin Lee 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 10 214-217 (4 pages)

Dong Hoon Shin, Seung Il Jung, Ki Nam Yun, Guohai Chen, Seok-Gy Jeon, Jung-Il Kim, Cheol Jin Lee 저
...
- 1,500원
A filtration-taping method was demonstrated to fabricate carbon nanotube (CNT) emitters. This method shows many good features, including high mechanical adhesion, good electrical contact, low temperature, organic-free, low cost, large size, and suitability for various CNT materials and substrates. These good features promise an advanced field emission performance with a turn-on field of 0.88 V/mm at a current density of 0.1 mA/cm2, a threshold field of 1.98 V/mm at a current density of 1 mA/cm2,...
2960.

Carbon nanospheres synthesized via solution combustion method: their application as an anode material and catalyst for hydrogen production

Vivek Dhand, M Venkateswer Rao, J. S. Prasad, Garima Mittal, Kyong Yop Rhee, Hyeon Ju Kim, Dong Ho Jung 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 7 198-202 (5 pages)

Vivek Dhand, M Venkateswer Rao, J. S. Prasad, Garima Mittal, Kyong Yop Rhee, Hyeon Ju Kim, Dong Ho Jung 저
...
- 1,500원
Amorphous agglomerates of carbon nanospheres (CNS) with a diameter range of 10-50 nm were synthesized using the solution combustion method. High-resolution transmission electron microscopy (HRTEM) revealed a densely packed high surface area of SP2-hybridized carbon; however, there were no crystalline structural components, as can be seen from the scanning electron microscopy, HRTEM, X-ray diffraction, Raman spectroscopy, and thermal gravimetric analyses. Electrochemical and thermo catalytic...

한주간 이슈검색어