학지사 뉴논문

총 1,885건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

471.

Mechanisms of Na adsorption on graphene and graphene oxide: density functional theory approach

Hye Sook Moon, Ji Hye Lee, Soonchul Kwon, Il Tae Kim, Seung Geol Lee 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 7 116-120 (5 pages)

Hye Sook Moon, Ji Hye Lee, Soonchul Kwon, Il Tae Kim, Seung Geol Lee 저
...
- 1,500원
to be stronger than the adsorption of Na on pristine graphene. However, the adsorption of Na on graphene oxide-hydroxyl resulted in the generation of NaOH as a by-product. Using density of states (DOS) calculations, we found that the DOS of the Na-adsorbed graphene was shifted down more than that of the Na-adsorbed graphene oxide-epoxide. In addition, the intensity of the DOS around the Fermi level for the Na-adsorbed graphene was higher than that for the Na-adsorbed graphene oxide-epoxide.
472.

The effects of stacking sequence on the penetration-resistant behaviors of T800 carbon fiber composite plates under low-velocity impact loading

Furqan Ahmad, Jung-Wuk Hong, Heung Soap Choi, Soo-Jin Park, Myung Kyun Park 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 6 107-115 (9 pages)

Furqan Ahmad, Jung-Wuk Hong, Heung Soap Choi, Soo-Jin Park, Myung Kyun Park 저
...
- 3,000원
impact load of 3.44 kg, corresponding to 23.62 J, was applied to the center of each plate supported at the boundaries. The unidirectional composite plate showed the worst impact resistance and broke completely into two parts; this was followed by the quasi-isotropic lay-up plate that was perforated by the impact. The cross-ply composite plate exhibited the best resistance to the low-velocity impact load; in this case, the impactor bounced back. Impact parameters such as the peak impact force and...
473.

Functionalization of graphene nanoplatelets using sugar azide for graphene/epoxy nanocomposites

Saswata Bose, Lawrence T. Drzal 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 5 101-106 (6 pages)

Saswata Bose, Lawrence T. Drzal 저
...
- 3,000원
evaluation of its thermo-mechanical performance. Successful functionalization of GnP was confirmed via thermal and spectroscopic study. Raman spectroscopy indicated that the functionalization was on the edge of the graphene sheets; the basal plane was not perturbed as a result of the functionalization. The epoxy/functionalized GnP composite system exhibited an increase in flexural modulus (~18%) and glass transition temperature (~10°C) compared to an un-functionalized GnP based epoxy composite.
474.

Effect of surface modification of carbon felts on capacitive deionization for desalination

Jong-Ho Lee, Hong-Joo Ahn, Donghwan Cho, Jeong-Il Youn, Young-Jig Kim, Han-Jun Oh 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 4 93-100 (8 pages)

Jong-Ho Lee, Hong-Joo Ahn, Donghwan Cho, Jeong-Il Youn, Young-Jig Kim, Han-Jun Oh 저
...
- 3,000원
during KOH chemical modification. However, the BET surface area significantly decreased by nitric acid (HNO3) chemical modification due to severe chemical dissolution of the pore structure. The capability of electrosorption by an electrical double-layer and the efficiency of capacitive deionization (CDI) thus showed the greatest enhancement by chemical KOH modification due to the appropriate increase of carboxyl and hydroxyl functional groups and the enlargement of the specific surface area.
475.

Characterization and influence of shear flow on the surface resistivity and mixing condition on the dispersion quality of multi-walled carbon nanotube/polycarbonate nanocomposites

Young Sil Lee, Kwan Han Yoon 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 3 86-92 (7 pages)

Young Sil Lee, Kwan Han Yoon 저
...
- 3,000원
by capillary and injection molding. Shear induced orientation of MWCNT was observed via scanning electron microscopy, in the direction of flow in a PC matrix during the extrusion process. The surface resistivity rose with increasing shear rate, because of the breakdown of the network junctions between MWCNTs. For real applications such as injection molding and the extrusion process, the amount of the MWCNT in the composite should be carefully selected to adjust the electrical conductivity.
476.

Activated carbons prepared from mixtures of coal tar pitch and petroleum pitch and their electrochemical performance as electrode materials for electric double-layer capacitor

Eunji Lee, Soon Hyung Kwon, Poo Reum Choi, Ji Chul Jung, Myung-Soo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 2 78-85 (8 pages)

Eunji Lee, Soon Hyung Kwon, Poo Reum Choi, Ji Chul Jung, Myung-Soo Kim 저
...
- 3,000원
AC electrodes from CTP and PP mixtures showed outstanding specific capacitance at higher current rates. In particular, CTP-PP61 (6:1 mixture) had the highest specific capacitance of 132 F/g, and the specific capacitance remained above 90% at a high current density of 3 A/g. It was found that the high specific capacitance could be attributed to the increased micro-pore volume of ACs with pore sizes from 1 to 2 nm, and the high power density could be attributed to the increased meso-pore volume.
477.

Preparation and characterization of carbon fiber-reinforced thermosetting composites: a review

Fan-Long Jin, Soo-Jin Park 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 1 67-77 (11 pages)

Fan-Long Jin, Soo-Jin Park 저
...
- 4,000원
mainly by the quality of interfacial adhesion between the CFs and the polymer matrix. Surface treatments of CFs are generally carried out to introduce chemical functional groups on the fiber surfaces, which provide the ability to control the surface characteristics of CFs. In this study, we review recent experimental studies concerning various surface treatment methods for CFs. In addition, direct examples of the preparation and properties of CF-reinforced thermosetting composites are discussed.
478.

Influence of Nitrogen moieties on CO2 capture of Carbon Aerogel

Da-Hee Jeon, Byung-Gak Min, Jong Gab Oh, Changwoon Nah and Soo-Jin Park 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 9 57-61 (5 pages)

Da-Hee Jeon, Byung-Gak Min, Jong Gab Oh, Changwoon Nah and Soo-Jin Park 저
...
- 1,500원
selectivity. In this work, N-doped carbon aerogels were prepared with different ratios of resorcinol/melamine by using the sol-gel method. The morphological properties were characterized by scanning electron microscopy (SEM). Nitrogen content was studied by X-ray photoelectron spectroscopy (XPS) and the specific surface area and micropore volume were analyzed by N2 adsorption-desorption isotherms at 77 K. The CO2 adsorption capacity was investigated by CO2 adsorption-desorption isotherms at 298...
479.

CO2 adsorption characteristics of slit-pore shaped activated carbon prepared from cokes with high crystallinity

Mi-Seon Park, Si-Eun Lee, Min Il Kim and Young-Seak Lee 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 7 45-50 (6 pages)

Mi-Seon Park, Si-Eun Lee, Min Il Kim and Young-Seak Lee 저
...
- 3,000원
crystal structure. The textural properties of hc-AC indicate that it consists mainly of slit-like pores. Compared to other textural forms of AC that have higher pore volumes, this slit-poreshaped hc-AC exhibits higher CO2 adsorption due to the similar shape between its pores and CO2 molecules. Additionally, in these high-crystallinity cokes, the main factor affecting CO2 adsorption at lower temperature is the pore structure, whereas the presence of oxygen functional groups on the surface has a...
480.

Preparation of sulfonated reduced graphene oxide by radiationinduced chemical reduction of sulfonated graphene oxide

Chang-Hee Jung, Ji-Hyun Hong, Jin-Mook Jung, In-Tae Hwang, Chan-Hee Jung and Jae-Hak Choi 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 6 41-44 (4 pages)

Chang-Hee Jung, Ji-Hyun Hong, Jin-Mook Jung, In-Tae Hwang, Chan-Hee Jung and Jae-Hak Choi 저
...
- 1,500원
method was sulfonated with the aryl diazonium salt of sulfanilic acid. Sulfonated graphene oxide (SGO) dispersed in ethanol was subsequently reduced by γ-ray irradiation at various absorbed doses to produce SRGO. The results of optical, chemical, and thermal analyses revealed that SRGO was successfully prepared by γ-ray irradiation-induced chemical reduction of the SGO suspension. Moreover, the electrical conductivity of SRGO was increased up to 2.94 S/cm with an increase of the absorbed dose.

한주간 이슈검색어