학지사 뉴논문

총 664건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

551.

Characterization and influence of shear flow on the surface resistivity and mixing condition on the dispersion quality of multi-walled carbon nanotube/polycarbonate nanocomposites

Young Sil Lee, Kwan Han Yoon 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 3 86-92 (7 pages)

Young Sil Lee, Kwan Han Yoon 저
...
- 3,000원
Multi-walled carbon nanotube (MWCNT)/polycarbonate (PC) nanocomposite was prepared by direct melt mixing to investigate the effect of the shear rate on the surface resistivity of the nanocomposites. In this study, an experiment was carried out to observe the shear induced orientation of the MWCNT in the polymer matrix using a very simple melt flow indexer with various loads. The compression-molded, should be eliminated. MWCNT/PC nanocomposite sample exhibited lower percolation thresholds (at 0.8...
552.

Influence of Nitrogen moieties on CO2 capture of Carbon Aerogel

Da-Hee Jeon, Byung-Gak Min, Jong Gab Oh, Changwoon Nah and Soo-Jin Park 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 9 57-61 (5 pages)

Da-Hee Jeon, Byung-Gak Min, Jong Gab Oh, Changwoon Nah and Soo-Jin Park 저
...
- 1,500원
by using the sol-gel method. The morphological properties were characterized by scanning electron microscopy (SEM). Nitrogen content was studied by X-ray photoelectron spectroscopy (XPS) and the specific surface area and micropore volume were analyzed by N2 adsorption-desorption isotherms at 77 K. The CO2 adsorption capacity was investigated by CO2 adsorption-desorption isotherms at 298 K and 1 bar. Melamine containing N-doped CAs showed a high nitrogen content (5.54 wt.%). The prepared N-doped...
553.

Carbon-allotropes: synthesis methods, applications and future perspectives

P. S. Karthik, A. L. Himaja and Surya Prakash Singh 한국탄소학회 Carbon Letters 19 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 1 219-237 (19 pages)

P. S. Karthik, A. L. Himaja and Surya Prakash Singh 저
...
- 4,800원
The element carbon has been used as a source of energy for the past few hundred years, and now in this era of technology, carbon has played a significant and very prominent role in almost all fields of science and technology. So as an honour to this marvellous element, we humans should know about its various forms of existence. In this review article, we shed light on all possible carbon-allotropes; similarities in their synthesis techniques and the starting materials; their wide range of...
554.

Pitch based carbon fibers for automotive body and electrodes

Kap Seung Yang, Bo-Hye Kim, Seong-Ho Yoon 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 2 162-170 (9 pages)

Kap Seung Yang, Bo-Hye Kim, Seong-Ho Yoon 저
...
- 3,000원
Pitch is an attractive raw material for carbon fiber precursors due to its low cost stemming from its availability as a residue of coking and petroleum processes. Ford Motor Company reported a carbon fiber target price of $11.0/kg by using a fast cycle-time manufacturing method with carbon fiber in an inexpensive format, allowing for an average retail price of gasoline of $3.58/gallon. They also recommended the use of carbon fiber with strength of 1700 MPa, modulus of 170 GPa, and 1.5%...
555.

Fabrication of isotropic bulk graphite using artificial graphite scrap

Sang-Min Lee, Dong-Su Kang, Woo-Seok Kim, Jea-Seung Roh 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 12 142-145 (4 pages)

Sang-Min Lee, Dong-Su Kang, Woo-Seok Kim, Jea-Seung Roh 저
...
- 1,500원
Isotropic synthetic graphite scrap and phenolic resin were mixed, and the mixed powder was formed at 300 MPa to produce a green body. New bulk graphite was produced by carbonizing the green body at 700°C, and the bulk graphite thus produced was impregnated with resin and re-carbonized at 700°C. The bulk density of the bulk graphite was 1.29 g/cm3, and the porosity of the open pores was 29.8%. After one impregnation, the density increased to 1.44 g/cm3 while the porosity decreased to 25.2%....
556.

Removal of methylene blue using lemon grass ash as an adsorbent

Harminder Singh, Dawa Tshering B 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 6 105-112 (8 pages)

Harminder Singh, Dawa Tshering B 저
...
- 3,000원
Wastewater from textile industries is a major cause of water pollution in most developing countries. In order to address the issues of water pollution and high cost for treatment processes, the use of an inexpensive and environmentally benign adsorbents has been studied. The objective was to find a better alternative to the conventional methods. Lemon grass waste (ash) collected from a lemon grass stream distillation subunit in Bhutan was tested for dye removal from aqueous solutions. The study...
557.

Superhydrophobic carbon-based materials: a review of synthesis, structure, and applications

Long-Yue Meng, Soo-Jin Park 한국탄소학회 Carbon Letters 16 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 5 89-104 (16 pages)

Long-Yue Meng, Soo-Jin Park 저
...
- 4,500원
Materials with appropriate surface roughness and low surface energy can form superhydrophobic surfaces, displaying water contact angles greater than 150°. Superhydrophobic carbon-based materials are particularly interesting due to their exceptional physicochemical properties. This review discusses the various techniques used to produce superhydrophobic carbon-based materials such as carbon fibers, carbon nanotubes, graphene, amorphous carbons, etc. Recent advances in emerging fields such as...
558.

Microwave heating of carbon-based solid materials

Teawon Kim, Jaegeun Lee, Kun Hong Lee 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 2 15-24 (10 pages)

Teawon Kim, Jaegeun Lee, Kun Hong Lee 저
...
- 3,000원
As a part of the electromagnetic spectrum, microwaves heat materials fast and efficiently via direct energy transfer, while conventional heating methods rely on conduction and convection. To date, the use of microwave heating in the research of carbon-based materials has been mainly limited to liquid solutions. However, more rapid and efficient heating is possible in electron-rich solid materials, because the target materials absorb the energy of microwaves effectively and exclusively....
559.

Hierarchical porous carbon nanofibers via electrospinning

Aikifa Raza, Jiaqi Wang, Shan Yang, Yang Si, Bin Ding 한국탄소학회 Carbon Letters 14 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 1 1-14 (14 pages)

Aikifa Raza, Jiaqi Wang, Shan Yang, Yang Si, Bin Ding 저
...
- 4,300원
applications accomplished by appropriately regulating the microstructural, mechanical, and electrical properties of as-spun CNFs. Additionally, the article describes the various strategies to make a variety of carbon CNFs for energy conversion and storage, catalysis, sensor, adsorption/separation, and biomedical applications. It is envisioned that electrospun CNFs will be the key materials of green science and technology through close collaborations with carbon fibers and carbon nanotubes.
560.

Size sorting of chemically modified graphene nanoplatelets

JoongTark Han, JeongIn Jang, SungHun Kim, SeungYol Jeong, HeeJin Jeong, Geon-Woong Lee 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2013, Vol.14 No.2 3 89-93 (5 pages)

JoongTark Han, JeongIn Jang, SungHun Kim, SeungYol Jeong, HeeJin Jeong, Geon-Woong Lee 저
- 1,500원

한주간 이슈검색어