학지사 뉴논문

총 1,202건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

571.

Advances in liquid crystalline nano-carbon materials: preparation of nano-carbon based lyotropic liquid crystal and their fabrication of nano-carbon fibers with liquid crystalline spinning

Yong-Mun Choi, in Jung Jun Yeon, Hwang Seung Min, Kim Hyeonsu Jeong, Bon-Cheol Ku, Munju Goh 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.4 1 223-232 (10 pages)

Yong-Mun Choi, in Jung Jun Yeon, Hwang Seung Min, Kim Hyeonsu Jeong, Bon-Cheol Ku, Munju Goh 저
...
- 3,000원
This review presents current progress in the preparation methods of liquid crystalline nanocarbon materials and the liquid crystalline spinning method for producing nano-carbon fibers. In particular, we focus on the fabrication of liquid crystalline carbon nanotubes by spinning from superacids, and the continuous production of macroscopic fiber from liquid crystalline graphene oxide.
572.

Mechanisms of Na adsorption on graphene and graphene oxide: density functional theory approach

Hye Sook Moon, Ji Hye Lee, Soonchul Kwon, Il Tae Kim, Seung Geol Lee 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 7 116-120 (5 pages)

Hye Sook Moon, Ji Hye Lee, Soonchul Kwon, Il Tae Kim, Seung Geol Lee 저
...
- 1,500원
to be stronger than the adsorption of Na on pristine graphene. However, the adsorption of Na on graphene oxide-hydroxyl resulted in the generation of NaOH as a by-product. Using density of states (DOS) calculations, we found that the DOS of the Na-adsorbed graphene was shifted down more than that of the Na-adsorbed graphene oxide-epoxide. In addition, the intensity of the DOS around the Fermi level for the Na-adsorbed graphene was higher than that for the Na-adsorbed graphene oxide-epoxide.
573.

The effects of stacking sequence on the penetration-resistant behaviors of T800 carbon fiber composite plates under low-velocity impact loading

Furqan Ahmad, Jung-Wuk Hong, Heung Soap Choi, Soo-Jin Park, Myung Kyun Park 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 6 107-115 (9 pages)

Furqan Ahmad, Jung-Wuk Hong, Heung Soap Choi, Soo-Jin Park, Myung Kyun Park 저
...
- 3,000원
impact load of 3.44 kg, corresponding to 23.62 J, was applied to the center of each plate supported at the boundaries. The unidirectional composite plate showed the worst impact resistance and broke completely into two parts; this was followed by the quasi-isotropic lay-up plate that was perforated by the impact. The cross-ply composite plate exhibited the best resistance to the low-velocity impact load; in this case, the impactor bounced back. Impact parameters such as the peak impact force and...
574.

Functionalization of graphene nanoplatelets using sugar azide for graphene/epoxy nanocomposites

Saswata Bose, Lawrence T. Drzal 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 5 101-106 (6 pages)

Saswata Bose, Lawrence T. Drzal 저
...
- 3,000원
evaluation of its thermo-mechanical performance. Successful functionalization of GnP was confirmed via thermal and spectroscopic study. Raman spectroscopy indicated that the functionalization was on the edge of the graphene sheets; the basal plane was not perturbed as a result of the functionalization. The epoxy/functionalized GnP composite system exhibited an increase in flexural modulus (~18%) and glass transition temperature (~10°C) compared to an un-functionalized GnP based epoxy composite.
575.

Effect of surface modification of carbon felts on capacitive deionization for desalination

Jong-Ho Lee, Hong-Joo Ahn, Donghwan Cho, Jeong-Il Youn, Young-Jig Kim, Han-Jun Oh 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 4 93-100 (8 pages)

Jong-Ho Lee, Hong-Joo Ahn, Donghwan Cho, Jeong-Il Youn, Young-Jig Kim, Han-Jun Oh 저
...
- 3,000원
during KOH chemical modification. However, the BET surface area significantly decreased by nitric acid (HNO3) chemical modification due to severe chemical dissolution of the pore structure. The capability of electrosorption by an electrical double-layer and the efficiency of capacitive deionization (CDI) thus showed the greatest enhancement by chemical KOH modification due to the appropriate increase of carboxyl and hydroxyl functional groups and the enlargement of the specific surface area.
576.

Activated carbons prepared from mixtures of coal tar pitch and petroleum pitch and their electrochemical performance as electrode materials for electric double-layer capacitor

Eunji Lee, Soon Hyung Kwon, Poo Reum Choi, Ji Chul Jung, Myung-Soo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 2 78-85 (8 pages)

Eunji Lee, Soon Hyung Kwon, Poo Reum Choi, Ji Chul Jung, Myung-Soo Kim 저
...
- 3,000원
of 900°C, and activation time of 3 h. The obtained ACs showed increased pore size distribution in the range of 1 to 2 nm and the highest specific capacitance of 122 F/g in a two-electrode system with an organic electrolyte, as measured by a charge-discharge method in the voltage range of 0-2.7 V. In order to improve the performance of the electric double-layer capacitor electrode, various mixtures of CTP and petroleum pitch (PP) were activated at the optimal activation conditions previously...
577.

Thermal properties in strong hydrogen bonding systems composed of poly(vinyl alcohol), polyethyleneimine, and graphene oxide

Sua Choi, Duck Kun Hwang and Heon Sang Lee 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 8 282-289 (8 pages)

Sua Choi, Duck Kun Hwang and Heon Sang Lee 저
...
- 3,000원
PEI. These abnormal increases of Tgs may be due to the negative entropy of mixing which is associated with strong hydrogen bonding between PVA and PEI. The degree of depression of s was not reduced by the negative entropy of mixing, since strong hydrogen bonding also causes an increase in the magnitude of negative c between PVA and PEI. The Tg of PVA was increased significantly by adding 0.7 wt.% GO into PVA. The magnitude of negative c was increased by adding GO into the blends of PVA and PEI
578.

Modification of isotropic coal-tar pitch by acid treatments for carbon fiber melt-spinning

Mi Jung Yoo, Hyo Jun Ko, Yun-Soo Lim and Myung-Soo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 3 247-254 (8 pages)

Mi Jung Yoo, Hyo Jun Ko, Yun-Soo Lim and Myung-Soo Kim 저
...
- 3,000원
yield and SP of the precursor pitch increased dramatically and the formation of meso-phase was suppressed due to the lower reaction temperatures. Since the precursor pitches with acid and thermal treatment were not spinnable due to the inhomogeneity of properties such as molecular weight distribution and viscosity, the CTP was mixed with ethanol before the consecutive nitric acid and thermal treatments. The precursor pitches with ethanol, nitric acid, and thermal treatments were easily spinnable...
579.

Overlook of carbonaceous adsorbents and processing methods for elemental mercury removal

Kyong-Min Bae, Byung-Joo Kim and Soo-Jin Park 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 2 238-246 (9 pages)

Kyong-Min Bae, Byung-Joo Kim and Soo-Jin Park 저
...
- 3,000원
concerned about mercury emissions for decades because of the extreme toxicity, persistence, and bioaccumulation of methyl Hg transformed from emitted Hg. This paper presents an overview of research related to mercury control technology and identifies areas requiring additional research and development. It critically reviews measured mercury emissions progress in the development of promising control technologies. This review provides useful information to scientists and engineers in this field.
580.

Method and mechanism of dispersing agent free dispersion of short carbon fibers in silicon carbide powder

Thakur Sudesh Kumar Raunija, Mariamma Mathew, Sharad Chandra Sharma 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 4 180-186 (7 pages)

Thakur Sudesh Kumar Raunija, Mariamma Mathew, Sharad Chandra Sharma 저
...
- 3,000원
A wide range of CFs loading, from 10 to 50 vol%, was studied. The milling of CFs and SiC powder was checked by measuring the average particle size of the composite powders. The dispersivity of CFs in SiC powder was checked through scanning electron microscope. The results show that the usage of exfoliated CF tows resulted in a rapid and effective milling of CFs and SiC powder. The results further show an excellent dispersion of CFs in SiC powder for all CFs loading without any dispersing agent.

한주간 이슈검색어