주제분류
더보기(12)자료유형
발행기관
- 대한생리학회-대한약리학회(278)
- 대한수의학회(272)
- 한국탄소학회(223)
- 한국식물병리학회(203)
- 한국열환경공학회(31)
- 한국습지학회(24)
- 대한생리학회(22)
- 대한약리학회(21)
- 한국기초간호학회(12)
- 대한신경정신의학회(11)
- 인문사회과학기술융합학회(11)
- 물리치료재활과학회(8)
- 대한치과교정학회(4)
- 한국청각언어재활학회(4)
- 한국웰니스학회(2)
- 한방비만학회(2)
- 환태평양유아교육연구학회(2)
- 고령자치매작업치료학회(1)
- 공주교육대학교 초등교육연구원(1)
- 대한구순구개열학회(1)
- 대한기계학회(1)
- 대한전자공학회(1)
- 대한지질공학회(1)
- 대한치과이식임플란트학회(1)
- 에너지기후변화교육학회(1)
- 이화여자대학교 교과교육연구소(1)
- 한국건설순환자원학회(1)
- 한국건축시공학회(1)
- 한국경호경비학회(1)
- 한국교원대학교 뇌기반교육연구소(1)
- 한국노년학연구회(1)
- 한국노인간호학회(1)
- 한국동력기계공학회(1)
- 한국목재공학회(1)
- 한국미생물생명공학회(1)
- 한국센서학회(1)
- 한국식품과학회(1)
- 한국심리치료학회(1)
- 한국음악치료학회(1)
- 한국자기학회(1)
- 한국전기전자재료학회(1)
- 한국전자파학회(1)
- 한국정보디스플레이학회(1)
- 한국초등체육학회(1)
- 한국콘크리트학회(1)
- 한국헬스커뮤니케이션학회(1)
- 한국환경생물학회(1)
간행물
- THE KOREAN JOURNAL OF PHYSIOLOGY & PHARMACOLOGY(278)
- CARBON LETTERS(223)
- JOURNAL OF VETERINARY SCIENCE(205)
- THE PLANT PATHOLOGY JOURNAL (181)
- 대한수의학회 학술대회발표집(34)
- KOREAN JOURNAL OF VETERINARY RESEARCH(구 대한수의학회지)(33)
- 열환경공학(29)
- 한국습지학회지(24)
- 대한생리학회지(22)
- 식물병연구(22)
- 대한약리학잡지(21)
- JOURNAL OF KOREAN BIOLOGICAL NURSING SCIENCE(12)
- 예술인문사회융합멀티미디어논문지(11)
- 신경정신의학(10)
- PHYSICAL THERAPY REHABILITATION SCIENCE(8)
- AUDIOLOGY AND SPEECH RESEARCH(4)
- THE KOREAN JOURNAL OF ORTHODONTICS(4)
- ASIA-PACIFIC JOURNAL OF RESEARCH IN EARLY CHILDHOOD EDUCATION(2)
- 대한한방비만학회지(2)
- 한국열환경공학회 학술대회지(2)
- 한국웰니스학회지(2)
- BRAIN, DIGITAL, & LEARNING(1)
- JOURNAL OF DENTAL IMPLANT RESEARCH(1)
- JOURNAL OF INFORMATION DISPLAY(1)
- JOURNAL OF MICROBIOLOGY AND BIOTECHNOLOGY(1)
- JOURNAL OF SEMICONDUCTOR TECHNOLOGY AND SCIENCE(1)
- KSME INTERNATIONAL JOURNAL(1)
- PSYCHIATRY INVESTIGATION(1)
- 고령자-치매작업치료학회지(1)
- 교과교육학연구(1)
- 교육논총(1)
- 노인간호학회지(1)
- 대한구순구개열학회지(1)
- 목재공학(1)
- 센서학회지(1)
- 시큐리티연구(1)
- 에너지기후변화교육(1)
- 전기전자재료학회지= THE JOURNAL OF THE KOREAN INSTITUTE OF ELECTRICAL AND ELECTRONIC MATERIAL ENGINEERS(1)
- 지질공학(1)
- 콘크리트학회논문집(1)
- 한국건설순환자원학회논문집(1)
- 한국건축시공학회지(1)
- 한국노년학연구(1)
- 한국동력기계공학회지(1)
- 한국식품과학회지(1)
- 한국심리치료학회지(1)
- 한국음악치료학회지(1)
- 한국자기학회지(1)
- 한국전자파학회논문지(1)
- 한국초등체육학회지(1)
- 헬스커뮤니케이션연구(1)
- 환경생물(1)
전체 선택해제
총 1,160건 검색
본문검색 결과만 보기
-
The effect of the spinning conditions on the structure of mesophase pitch-based carbon fibers by Taguchi method
Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 한국탄소학회 Carbon Letters 10 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 11 89-98 (10 pages)
higher spinning temperature, a reduced winding speed, and an increased extrusion pressure. The winding speed was found to be the most significant factor in relation to the fiber diameter. While it was observed that thicker carbon fiber generally shows improved preferred orientation, the most important variable affecting the preferred orientation was found to be the entry angle. As the entry angle decreased from 120° to 60°, the shear flow was enhanced to induce more ordered radial alignment of... -
Adsorptive removal of atmospheric pollutants over Pyropia tenera chars
Heejin Lee, Rae-su Park, Hyung Won Lee, Yeojin Hong, Yejin Lee, Sung Hoon Park, Sang-Chul Jung, Kyung-Seun Yoo, Jong-Ki Jeon, Young-Kwon 한국탄소학회 Carbon Letters 10 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 10 79-88 (10 pages)
As a replacement for activated carbon, biochar was synthesized and used for the adsorptive removal of formaldehyde and nitrogen oxide. Biochar was produced from the fast pyrolysis of the red marine macro alga, Pyropia tenera. The P. tenera char was then activated with steam, ammonia and KOH to alter its characteristics. The adsorption of formaldehyde, which is one of the main indoor air pollutants, onto the seaweed char was performed using 1-ppm formaldehyde and the char was activated using a... -
Waste coffee grounds-derived nanoporous carbon nanosheets for supercapacitors
Min Hong Park, Young Soo Yun, Se Youn Cho, Na Rae Kim, Hyoung-Joon Jin 한국탄소학회 Carbon Letters 6 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 8 66-71 (6 pages)
The development of nanostructured functional materials derived from biomass and/or waste is of growing importance for creating sustainable energy-storage systems. In this study, nanoporous carbonaceous materials containing numerous heteroatoms were fabricated from waste coffee grounds using a top-down process via simple heating with KOH. The nanoporous carbon nanosheets exhibited notable material properties such as high specific surface area (1960.1 m2 g?1), numerous redox-active heteroatoms... -
Yield enhancement of matrix precursor in short carbon fiber reinforced randomly oriented carbon/carbon composite
Thakur Sudesh Kumar Raunija, Sharad Chandra Sharma, Anil Verma 한국탄소학회 Carbon Letters 9 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 7 57-65 (9 pages)
Isroaniso matrix precursor synthesized from commercially available petroleum pitch was stabilized in air. The influence of oxygen mass gain during stabilization on the yield of matrix precursor was studied. Additionally, the influence of pressure on the yield of the stabilized matrix precursor in a real system was studied. The fourier transform infrared spectrometry (FTIR), thermogravimetric analysis (TGA), yield, yield rate, and yield impact were used to check the effect of stabilization and... -
Effect of fiber-matrix adhesion on the fracture behavior of a carbon fiber reinforced thermoplastic-modified epoxy matrix
H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 한국탄소학회 Carbon Letters 10 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 6 47-56 (10 pages)
In this study, the fracture behavior of a thermoplastic-modified epoxy resin reinforced with continuous carbon fibers for two levels of fiber-matrix adhesion was performed. A carbon fiber with commercial sizing was used and also treated with a known silane, (3-glycidoxy propyl trimethoxysilane) coupling agent. Toughness was determined using the double cantilever test, together with surface analysis after failure using scanning electron microscope. The presence of polysulfone particles improved... -
Study on urea precursor effect on the electroactivities of nitrogen-doped graphene nanosheets electrodes for lithium cells
Ki-Yong Kim, Yongju Jung, Seok Kim 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 5 40-46 (7 pages)
due to its low cost and easy preparation. To find the optimum urea content, we tested three different ratios of urea to graphene oxide. The morphology of the composites was examined by field emission scanning electron microscope. Functional groups and bonding characterization were measured by X-ray photoelectron spectroscopy. Electrochemical properties were characterized by cyclic voltammetry in an organic electrolyte solution. Compared with thermally reduced graphene/sulfur (S) composite,... -
Phenylethynyl-terminated polyimide, exfoliated graphite nanoplatelets, and the composites: an overview
Donghwan Cho, Lawrence T. Drzal 한국탄소학회 Carbon Letters 11 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 1 1-11 (11 pages)
high-temperature sizing material for carbon fiber-reinforced polymer matrix composites, PETI-5 imidization and thermal curing behaviors have been extensively investigated based on the phenylethynyl end-group reaction. These studies are reviewed here. In addition, the use of PETI-5 to enhance interfacial adhesion between carbon fibers and a bismaleimide (BMI) matrix, as well as the dynamic mechanical properties of carbon/BMI composites, are discussed. Reports on the thermal expansion behavior of... -
Atmospheric chemical vapor deposition of graphene on molybdenum foil at different growth temperatures
Samira Naghdi, Kyong Yop Rhee, Man Tae Kim, Babak Jaleh, Soo Jin Park 한국탄소학회 Carbon Letters 6 Pages
한국탄소학회 Carbon Letters 2016, Vol.18 6 37-42 (6 pages)
the Mo surface; the presence of carbide was more intense at 1200°C. Additionally, a higher I2D/IG ratio (0.418) was observed at 1200°C, which implies that there are fewer graphene layers at this temperature. The lowest ID/IG ratio (0.908) for the graphene layers was obtained at 1200°C, suggesting that graphene had fewer defects at this temperature. The size of the graphene domains was also calculated. We found that by increasing the growth temperature, the graphene domain size also increased. -
Microstructural changes of polyacrylonitrile-based carbon fibers (T300 and T700) due to isothermal oxidation (1): focusing on morphological changes using scanning electron microscopy
Seong-Moon Oh, Sang-Min Lee, Dong-Su Kang, Jae-Seung Roh 한국탄소학회 Carbon Letters 6 Pages
한국탄소학회 Carbon Letters 2016, Vol.18 3 18-23 (6 pages)
than that of T700 fibers. The diameter of T700 fibers decreased linearly with increasing burn-off. The diameter of T300 also decreased with increasing burn-off but at slower rates over time. Cross-sectional observations after oxidation reactions revealed hollow cores in the longitudinal direction for both T300 and T700 fibers. The formation of hollow cores after oxidation can be traced to differences in the fabrication process such as the starting material and final heat treatment temperature. -
Monolithic porous carbon materials prepared from polyurethane foam templates
Jo?o Pires, Andr? Janeiro, Filipe J. Oliveira, Alexandre C. Bastos, Mois?s L. Pinto 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2016, Vol.18 2 11-17 (7 pages)
Monolithic carbon foams with hierarchical porosity were prepared from polyurethane templates and resol precursors. Mesoporosity was achieved through the use of soft templating with surfactant Pluronic F127, and macroporosity from the polyurethane foams was retained. Conditions to obtain high porosity materials were optimized. The best materials have high specific surface areas (380 and 582 m2 g?1, respectively) and high electrical conductivity, which make them good candidates for supports in...
