학지사 뉴논문

총 1,012건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

771.

The effects of stacking sequence on the penetration-resistant behaviors of T800 carbon fiber composite plates under low-velocity impact loading

Furqan Ahmad, Jung-Wuk Hong, Heung Soap Choi, Soo-Jin Park, Myung Kyun Park 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 6 107-115 (9 pages)

Furqan Ahmad, Jung-Wuk Hong, Heung Soap Choi, Soo-Jin Park, Myung Kyun Park 저
...
- 3,000원
Impact damages induced by a low-velocity impact load on carbon fiber reinforced polymer (CFRP) composite plates fabricated with various stacking sequences were studied experimentally. The impact responses of the CFRP composite plates were significantly affected by the laminate stacking sequences. Three types of specimens, specifically quasi-isotropic, unidirectional, and cross-ply, were tested by a constant impact carrying the same impact energy level. An impact load of 3.44 kg, corresponding to...
772.

Activated carbons prepared from mixtures of coal tar pitch and petroleum pitch and their electrochemical performance as electrode materials for electric double-layer capacitor

Eunji Lee, Soon Hyung Kwon, Poo Reum Choi, Ji Chul Jung, Myung-Soo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 2 78-85 (8 pages)

Eunji Lee, Soon Hyung Kwon, Poo Reum Choi, Ji Chul Jung, Myung-Soo Kim 저
...
- 3,000원
current density of 1 A/g, the AC electrodes from CTP and PP mixtures showed outstanding specific capacitance at higher current rates. In particular, CTP-PP61 (6:1 mixture) had the highest specific capacitance of 132 F/g, and the specific capacitance remained above 90% at a high current density of 3 A/g. It was found that the high specific capacitance could be attributed to the increased micro-pore volume of ACs with pore sizes from 1 to 2 nm, and the high power density could be attributed to the...
773.

Preparation and thermal properties of polyethylene-based carbonized fibers

Kwan-Woo Kim, Hye-min Lee, Byoung Suhk Kim, Seon-Hwan Hwang, Lee-Ku Kwac, Kay-Hyeok An and Byung-Joo Kim 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 10 62-66 (5 pages)

Kwan-Woo Kim, Hye-min Lee, Byoung Suhk Kim, Seon-Hwan Hwang, Lee-Ku Kwac, Kay-Hyeok An and Byung-Joo Kim 저
...
- 1,500원
In this study, carbonized fibers were prepared by using acidically cross-linked LDPE fibers. The surface morphologies of the carbonized fibers were observed by SEM. The effects of cross-linking process temperatures were studied using thermal analyses such as DSC and TGA. The melting and heating enthalpy of the fibers decreased as the cross-linking temperature increased. The cross-linked fibers had a carbonization yield of over 50%. From SEM results the highest yield of carbonized LDPE-based...
774.

Influence of hot-pressing pressure on the densification of short-carbon-fiber-reinforced, randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija and Sharad Chandra Sharma 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 4 25-33 (9 pages)

Thakur Sudesh Kumar Raunija and Sharad Chandra Sharma 저
...
- 3,000원
microstructure and density. The results showed that effective densification strongly depended on the hot-pressing pressure and reinforcement wt%. Furthermore, results showed that compacts processed at lower hot-pressing pressure, and at higher reinforcement wt%, gained density gradually during three densification cycles and showed the symptoms of further gains with additional densification cycles. In contrast, samples that were hot-pressed at moderate pressure and at moderate reinforcement wt%,...
775.

Breakthrough behaviour of activated charcoal cloth samples against oxygen analogue of sulphur mustard

G. K. Prasad, J. Praveen Kumar, P. V. R. K. Ramacharyulu and Beer Singh 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 3 19-24 (6 pages)

G. K. Prasad, J. Praveen Kumar, P. V. R. K. Ramacharyulu and Beer Singh 저
...
- 3,000원
purpose. Breakthrough behaviour was found to depend on the properties of the activated charcoal cloth, properties of the OA and the adsorption conditions. Activated charcoal cloth with a high surface area of 1290 m2/g, relatively large surface density of 160 g/m2 and coarser fiber structure exhibited better kinetic saturation capacity value, 0.19 g/g, against OA vapours when compared to others, thus confirming its potential use in foldable masks for protection against chemical warfare agents.
776.

An overview of new oxidation methods for polyacrylonitrile?based carbon fibers

Hye Kyoung Shin, Mira Park, Hak-Yong Kim and Soo-Jin Park 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 2 11-18 (8 pages)

Hye Kyoung Shin, Mira Park, Hak-Yong Kim and Soo-Jin Park 저
...
- 3,000원
The process of oxidizing polyacrylonitrile (PAN)-based carbon fibers converts them into an infusible and non-flammable state prior to carbonization. This represents one of the most important stages in determining the mechanical properties of the final carbon fibers, but the most commonly used methods, such as thermal treatment (200°C to 300°C), tend to waste a great deal of process time, money, and energy. There is therefore a need to develop more advanced oxidation methods for PAN precursor...
777.

Carbon nanotubes synthesis using diffusion and premixed flame methods: a review

Garima Mittal, Vivek Dhand, Kyong Yop Rhee, Hyeon-Ju Kim and Dong Ho Jung 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 1 1-10 (10 pages)

Garima Mittal, Vivek Dhand, Kyong Yop Rhee, Hyeon-Ju Kim and Dong Ho Jung 저
...
- 3,000원
The production yield can be optimized by altering various parameters such as fuel profile, equivalence ratio, catalyst chemistry and structure, burner configuration and residence time. In the present report, diffusion and premixed flame synthesis methods are reviewed to develop a better understanding of factors affecting the morphology, positioning, purity, uniformity and scalability for the development of carbon nanotubes along with their correlated carbonaceous derivative nanostructures.
778.

Thermal properties in strong hydrogen bonding systems composed of poly(vinyl alcohol), polyethyleneimine, and graphene oxide

Sua Choi, Duck Kun Hwang and Heon Sang Lee 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 8 282-289 (8 pages)

Sua Choi, Duck Kun Hwang and Heon Sang Lee 저
...
- 3,000원
Blends of poly(vinyl alcohol) (PVA), polyethyleneimine (PEI), and graphene oxide (GO) were prepared by solution casting method. Calorimetric thermal properties of the blends were investigated. The Tgs of PVA/PEI blends were higher than the Tgs of either of the component polymers at low concentrations of PEI. These abnormal increases of Tgs may be due to the negative entropy of mixing which is associated with strong hydrogen bonding between PVA and PEI. The degree of depression of s was not...
779.

Carbon-allotropes: synthesis methods, applications and future perspectives

P. S. Karthik, A. L. Himaja and Surya Prakash Singh 한국탄소학회 Carbon Letters 19 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 1 219-237 (19 pages)

P. S. Karthik, A. L. Himaja and Surya Prakash Singh 저
...
- 4,800원
The element carbon has been used as a source of energy for the past few hundred years, and now in this era of technology, carbon has played a significant and very prominent role in almost all fields of science and technology. So as an honour to this marvellous element, we humans should know about its various forms of existence. In this review article, we shed light on all possible carbon-allotropes; similarities in their synthesis techniques and the starting materials; their wide range of...
780.

Excellent field emission properties from carbon nanotube field emitters fabricated using a filtration-taping method

Dong Hoon Shin, Seung Il Jung, Ki Nam Yun, Guohai Chen, Seok-Gy Jeon, Jung-Il Kim, Cheol Jin Lee 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 10 214-217 (4 pages)

Dong Hoon Shin, Seung Il Jung, Ki Nam Yun, Guohai Chen, Seok-Gy Jeon, Jung-Il Kim, Cheol Jin Lee 저
...
- 1,500원
A filtration-taping method was demonstrated to fabricate carbon nanotube (CNT) emitters. This method shows many good features, including high mechanical adhesion, good electrical contact, low temperature, organic-free, low cost, large size, and suitability for various CNT materials and substrates. These good features promise an advanced field emission performance with a turn-on field of 0.88 V/mm at a current density of 0.1 mA/cm2, a threshold field of 1.98 V/mm at a current density of 1 mA/cm2,...

한주간 이슈검색어