A new approach for the design of extrusion die surface of arbitrarily shaped section is presented. In order to generate the extrusion die surface. an automatic surface construction method based on B-spline surface and scalar field theory is proposed. The isothermal lines and stream lines designed in the scalar field are introduced to find the control points which are used in constructing B-spline surfaces. Intersected points between the isothermal lines and stream lines are used to construct B-spline surfaces. The inlet and outlet profiles are precisely described with B-spline curves by using the centripetal method for uniform parameterization. The extrusion die surface is generated by using the cubic curve interpolation in the u- and v-directions. A quantitative measure for the control of surface is suggested by introducing the tangential vectors at the inlet and outlet sections. To verify the validity and effectiveness of the proposed method, automatic surface generation is carried out for extrusion dies of arbitrarily shaped sections.