Recently, a study for the functional surface production of super hydrophobic of natural and biomimetic artificial has attracted much attention. To make process methods of super hydrophobic surface has a variety of ways such as lithography, etching, and laser ablation. However, we were used ultra-shot pulse laser ablation process which has the virtue of more environmental friendliness and simple process. In this paper, we were fabricated a multiplicity of super hydrophobic patterns on mold surface(NAK80) using by optimizing the laser processing conditions and it was transferred on PDMS. Also, we measured contact angle super hydrophobic patterns on PDMS. The result showed there is no patterns on PDMS were measured 94 degrees, by contrast, optimized super hydrophobic patterns on PDMS was 157 degrees. Therefore we fabricated super hydrophobic surface on mold. Based on these experimental results, it is possible to mass production using ultra shot pulse laser ablation of super hydrophobic pattern and to be applied for a variety of industries.